
Appendix A: Configuration File Description
38 ManageUPSNET User Instruction Manual
Appendix A:
Configuration File
Description
The ManageUPSNET configuration file is an
ASCII text based file which uses a “parameter =
value” format to describe each entity. This file
can be uploaded to the adapter using TFTP or
FTP. The table below describes each possible
entity. If an entity is missing from an uploaded
file then that entity will simply not be updated in
any way.
Table 5. Configuration File Description
Parameter Name Description
ip
The IP address.
sm
The Subnet Mask used.
gw
The Default Route used
bootp
BOOTP enabled flag – determines if BOOTP should be used to
obtain network information at startup time.
0 = disabled
1 = enabled
sysName
The name of the system.
sysLocation
The physical location of this UPS.
sysContact
The name of the person to contact regarding this UPS.
identName
A descriptive name of the UPS.
identAttachedDevices
A description of the devices attached to this UPS.
snmpCommunity0 –
•
•
snmpCommunity9
10 sets of 3 tuples, separated by semi-colons, specifying the
SNMP communities. These tuples are
• Community Name
• IP Address
• Permissions (READ, WRITE or READ_WRITE)
Inactive community entries should include only the parameter
name and equal sign (i.e.
snmpCommunity9=
).
snmpTrapDest0
•
•
snmpTrapDest9
10 sets of 3 tuples, separated by semi-colons, specifying
SNMP trap information. These tuples are
• Trap Community
• Trap Destination Address
Inactive trap entries should include only the parameter name
and equal sign (i.e.
snmpTrapDest9=
)
snmpAuthenticateTraps
A value of 1 enables traps on authentication errors while a
value of 0 disables them.
Commenti su questo manuale